Leaderboard

Well, then it just ups the statistic, that these mounts unlike whiteline com-c so far work fine for most and can be considered for those that wish more camber w/o compromising NVH.

Hmm, from looks of those LCAs, they have also adjustment of track .. but doesn't that adjustment not only changes track, but also changes camber? And toe adjusment, doesn't it change both toe & camber? In general, by that painted line over trick over you may check everything that is adjustable in suspension, to see culprit, which had moved, not just camberbolts. Also, what struts you have? Maybe height adjustable? Do adjusting collars stay snug? In general, as many using camberbolts also auto-x or HPDE their cars including going over kerbs, and for most camberbolts stay as they were when tightened, i suspect something else at fault. If for camberbolts themselves - then eg. misused some type of grease which may reduce friction and increase chance of slip. If it's single clunk over bumps .. hmm, i'd check state of bushings and wheel bearing. Metallic clunk .. especially i'd check state of pillowball bushings, if somewhere are such, and also if some tie/endlink doesn't rub somewhere. For me source of metallic clunk over some bumps was eg. when topmounts where pillowball camberplates :), hence what i wished to fix by reverting to rubber topmounts but retaining extra camber. Seen cases in forums of eg. some aftermarket suspension/coilovers/swaybars combo, where with specific endlink length it rubbed when that corner was bottomed out.

Hmm, interesting. Can you post a link, what are those widetrack LCAs? As for camberbolts, weird. Imho something is off/wrong. They shouldn't slip, normally torqued, they don't for most, if they do, probably there had been some some heavy hit to suspension, that might aswell also bend something. Hmm, maybe you have applied some antiseize grease or alike? (which should increase torque value to provide same level of friction to not slip .. maybe even past camberbolt shearing torque). Well, regarding camberbolts usage i may add two hints i've seen in forums: 1) when adjusting alignment, at end worth to paint line over bolt head & joint, so that one can see, if it has moved or not, and one can easily turn back to orig position, 2) seen DIY ways to ensure for bolts to never slip (though they were mentioned more in context of bolt within larger, slotted strut hole, less about lobed camberbolts) - to glue it. Saw mentions of eg. blue loctite, paint or even fingernail paint , to apply under washer sides and head of the bolt and under flange of the nut. Also, can you be more specific on describing that clunking noise? I wonder if it is from topmounts at all. Issues with topmounts noises usually are when their bearing binds, so then when turning wheel lock to lock there might be noises of coil spring "skipping" in spring perch. But that binding bearing / skipping spring noise is just from turning wheel, not exactly clunking when driving over bumps, as you wrote, so makes me think if topmount is source of that at all?